Rinse, drain and fill but with 1 tap ... how smart and convenient is that!
Protherm has this special faucet in its range. A special faucet with only one appendage for 2 separate ball valves and drain. This perfect combination saves on labor and materials. With far fewer parts and therefore quick to install. This valve is available with various sizes of compression fittings or with a female thread connection. To be mounted in any desired position. Always follow the manufacturer's instructions when installing.
Child's Play
Placement of flush drain valves in both supply and return makes flushing and filling installations child's play. The circuit of the heat pump or solar collector is closed off by the main ball valves. Both the system side and the source (heat pump or solar collector) are now interrupted from each other and can both be filled or flushed individually. The flushing and filling device is connected to the fill and drain valves on the supply and return sides. Flushing or filling begins. Then the taps are closed again and the main valves are put into operating position. The fill and drain valve is locked by unscrewing the levers, turning them 180 degrees and screwing them back on.
Shorter
These particular faucets are available with various sizes of compression fittings (15-22-28mm) or with a 1" female thread connection. The 3/4″ connections (to flush/fill/drain) come with a sealing cap. The flush drain valve from Protherm: that means easier flushing, also functioning as a shut-off valve, flexible application and, very importantly, with a much shorter installation size. And therefore with far fewer parts that you normally need for this type of faucet ... in other words, here too, saving time and less chance of failure costs.
You can find PROTHERM-IMPEX B.V. in hall 11, booth E080 | Meet now